Rutgers Center for Ocean Observing Leadership

Corresponding Pictures of the Spectra

Ships are on the spectra map!

These are pictures of the spectra readings from this afternoon as ships passed by each other at the same time. We have video and additional pictures of this happening but you can clearly see the boats cross past each other in the spectra. One was at about 400 m and the other at 500 m



River Sonde Update: Friday, June 18

Below are general time series and radial plots over the last 24 hours.  Positive along-shore velocities reflect water moving south towards the Hudson Estuary; positive cross-shore velocities reflect water traveling across towards NYC:

Even though we are pleased with the radial profile, we are skeptical about the along-shore and cross-shore measurements taken by the River Sonde.  We were hoping for more clarity in our data (less standard deviation), but knowing how rapidly the physical properties of the Hudson change, the River Sonde might be giving accurate measures.  According to the River Sonde manuel, a typical time series plot looks like:

The above plot is over five days, so we manipulated parameters on our own time series plot to (hopefully) look more like the above.  Over 48 hours, the average along-shore and cross-shore velocities look as such:

Time series over 48 hours

Along-shore average velocities over the last 48 hours

Cross-Shore average surface velocities over the last 48 hours

There are similarities between our measurements and ideal measurements, but there is still ambiguity in the data.

For more comparison, we are including the NYHOPS river model from the last 12 hours, and a prediction for the next 48 hours:

Assuming that the NYHOPS model are showing magnitudes of the velocity measurements, the River Sonde and NYHOPS model are comparable, and there are few discrepancies between them.  Thus, we feel more confident in the River Sonde and its accuracy.

-The Radar Team

RiverSonde was not Transmitting

I spoke with Hector at Codar yesterday and we got the RiverSonde working.  I had turned off the transmitter when we were setting up the system because it is not good to transmit while the antenna is not connected to the amplifier.  This is what the spectra should look like.

I learned yesterday that positive currents are to the right when behind the antenna.  The antenna that transmits the signal is antenna 2.  while behind the antenna, from left to right it is antenna 1, 2 then 3.

Here are the correct setting for Receiver controller.  This application transmits the radio signal.

This is a simplified version of SeaSonde Controller.

Screen Shots from RiverSonde

Here is the screen shot of the time series plot

Here is the screen shot of the profile plot

here is the screen shot of the latest radial map

THINGS TO DO FOR THE SUMMER

1. Install River Sonde

2. Verify if River Sonde is running properly

3. Determine if Riversonde can detect small vessels

4. Try to make river sonde work on top of the buiding HOWE.

5. try riversonde on the beach

6.coordinate an exercise with other teams.

SECTIONS FOR PAPER

SECTION PEOPLE

1. ABSTARCT – EVERYONE
2. INTRODUCTION – ANGELICA
3. BACKGROUND – LENNY
4. HYPOTHESIS – DANIELLE
5. METHODOLOGY – OMAR
6. RESULTS – SHANKAR
7. DISCUSSION – DAKOTA

RiverSonde Config Parameters

Here are screen captures of the setup we did on friday June 11, 2010.

LEAP Performance Report response

Hugh,

I decided to pick these vessels, because the Orange track has an interesting track, just moving outside of Barnegat. Sometimes ship detection notice some interesting boats just hanging out. The darker blue and green track I choose because there are some instances where the detection have some gaps. Both ships have similar radial velocity and distance, but different bearing. I am curious on how would the code resolve the differences, and see how it does with the gaps. The yellow track seems to be a straight line down south on the map, however, on the second graph, the vessel shows gradual change in distance to the radar as well as in bearing. Seems interesting on how the vessel moves. If you, see other vessels that need to be included please let me know.

LEAP Performance Report

Erick, how did you decide that you’ll plot 7 ships?  Can you plot them all?